|
Servo and Signals |
|||
| Attaching a Signal to a Servo Motor and Servo Motor Controller | |||
| A hole is drilled through the signal base and the baseboard. | |||
| With both signal and Servo Motor in midpoint position a wire is attached from the signal balance weight to the Servo Motor arm. | |||
 |
 |
||
| Connection of the Servo Motor is made to the Servo Motor Controller. | |||
| The adjustment for the two signal positions can now be made Details | |||
| The arm movement change operates the signal. | |||
| The speed of movement may be adjusted. | |||
| To automate replace the switch by an IRDASC, IRDOT-3D or SA relay | |||